If you are a metal artist or want to become a metal artist you will need some tools. Not some simple hand tools like hammers and ratchets. You will probably need to invest some real money into things like welders and torches. Why you ask? Metal Art making is a bit more expensive then driftwood art.
You must have seen those alloy wheels that lend a ride that swanky, sporty look. Much as these large diameter alloy wheels look good and improve performance, over time speed and road conditions cause a lot of wear and tear. The cyclical stress is high and the ventilation, disk attachment holes, the flange as well as the rim take a toll. The result? Cracks, dents, bends and scratches all start to show.
It is hard to understand what these places can produce that could be useful for the average person. In fact almost everything we use and buy comes in no small part from these plants. One of the biggest commodities that are used is sheet Sheet metal fabrication Bayswater.
Going custom is not as hard as you may think. All you need to do is find a person that does a custom design for people to purchase. This is not as much fun but you do get to figure out what you are going to have your bike look like and gives you a chance to be different.
The center of gravity calculation sounds complex, but it really isn’t. The poor mans way to get the center of gravity is to take two scales (or if you are poor yet one scale) and place it where the wheels would be located. (Thing to keep in mind is that an equivalent weight of a person(s) needs to be included and distributed properly.) When the scale reads one half the total weight, you have a 50/50 weight distribution.
Electric welders and grinders have hazards normally associated with electricity. Make sure that the machines are of compatible voltage and the wiring is in good repair and well insulated. Hot work can easily damage the insulation of welding and grinding equipment so it needs to be inspected frequently and properly protected during the hot work process.
There are some safety measures that should be considered when using these cutting tools. Every industry introduces its workers to a lot of power hazards before they start using the cutting tools. For instance using the CNC Plasma Cutting Machines, proper eye protection like welding goggles should be used to prevent eye damage from debris commonly known as arc eye. Machines like band saws and the brake press should only be used by qualified workers to avoid any form of accidents. Protective gear should be won all the time at the industry to prevent head injuries in case an accident occurs. Remember prevention is always better than cure.